The Bubble Magus BM-T01 is an accurate micro-computer controlled, three-channel dosing pump. Can be used to automatically dose 2-part calcium / alkalinity additives, trace elements, magnesium, strontium, kalkwasser, or just about any liquid additive for your aquarium.

The dosing pump provides 3 dosing channels and can be extended to 7 or 11 channels with the BM-T02. It also features automatic time-sharing between channels, so different liquids will not be added to the aquarium at the same time to prevent chemical interference. A microchip with built-in storage memory will save your setting in case of a power outage. The BM-T01 dosing pump also features high-quality medical-grade rubber hoses with an average service life of 10,000 hours and high-torque motors that are quiet and durable. The pump shell is made with automotive grade instrument-level high-strength self-lubricating plastic POM. The control panel is water-proof with a back-lit LCD display. The programming is simple, precise, clear and intuitive using "easy dialogue" for operating the controls.

To setup:

(1) Set the time
- press escape
- use the up/down buttons to select set time, press enter
- set the time using the up/down buttons for each digit and press enter

(2) Connect lines
- standard air line tubing fits nice and snug
- input is on the left, output on the right

(3) Prime the pump
- press escape
- use the up/down buttons to select manual control, press enter
- select the pump using the up/down button - pump 1,2 & 3 are on the primary unit, 4,5,6 & 7 on the secondary (An additional add-on would continue the trend)
- press and hold enter to manually run the pump until the air bubbles are out and the line is full

(4) Configure pump for dosing
- press escape
- use the up/down buttons to select setup program
- use the up/down button to select 1-3 for the primary unit, or 4-7 for the secondary
- use the up/down to select the pump number
- set the ml/day using the up/down buttons for each digit and press enter. you can select from 1-1999 ml.
- set the cycles per day and press enter. These are based on the following table:
Dose amount (mL): Cycles/day
1: 1,2
2: 1,2,3,4
3: 1,2,3,4,6
4-5: 1,2,3,4,6,8
6-11: 1,2,3,4,6,8,12
12-160: 1,2,3,4,6,8,12,24
161-319: 2,3,4,6,8,12,24
320-479: 3,4,6,8,12,24
480-639: 4,6,8,12,24
640-959: 6,8,12,24
960-1279: 8,12,24
1280-1919: 12,24
1920-1999: 24

- set the start time (take note you can only select the start hour, press enter. the minutes are pre-determined based on the pump number). For example P1-:00 P2-:05 P3-:10 and so on.

NOTE- the pumps are forced to run one at a time to prevent mixing of chemicals.

-press esc to return to the main screen